When crossing gateways it is recommended to se insulated 2.5mm cable buried at least 300mm (12") underground. In heavy traffic areas, run the insulated cable through irrigation tubing for extra protection before it is buried. Ensure that the ends of the tubing are turned down to prevent water from entering. Overhead crossings are not recommended as they are susceptible to damage.

• Attach each end of the insulated cable to the fence line with joint clamps.
• If the fence system is a fence earth return system, run an earth cable as well as the live cable under the gateway.
• Always use 2.5mm cable as it is more conductive than 1.6mm cable
• Never use household electrical cable under gateways.
• Never use spring gates or tape gates instead of insulated cable to carry the current across the gateway.
• Where there is an earth cable and a live cable crossing a gateway, mark the cables to prevent cross-connection.
• Always allow extra cable, to avoid joins.

STAFIX GATE HARDWARE

Flood gates are ideal for use in creeks, river beds and other areas prone to flooding. Strain a wire between two posts (one on either side of the creek). Clamp on lengths of galvanised chain hung at intervals of 150mm (6"). For large animals this can be increased to 300mm (12"). The length of the chain is kept to 300mm (12") above the lowest average water level. The flood gate controller is connected between the fence and the flood gate. This limits the amount of power on the flood gate during a flood so that the remainder of the fence continues to have a high voltage. Placement of a cutout switch is recommended where there is a likelihood of water levels remaining high for extended periods of time.